Glue for steel BH adapters???

[Phil Tuccillo]

What kind have you guys had the best luck with?
                              Thanks, Phil

[The Vanilla Gorilla]

Amber hot melt or JB weld

[David Mitchell]

Amber hot melt here also.

[Phil Tuccillo]

Who carries amber hotmelt?

[The Vanilla Gorilla]

Originally posted by Phil Tuccillo:
Who carries amber hotmelt?

Usually get mine from The Nocking Point.  Fastest and cheapest shipping I've found.

[Reaper TN]

I've used JB Weld and Loctite 2 part epoxy with good results.

[TxAg]

Gorilla super glue works great....hard to to change out adapters, though

[amar911]

Marine grade epoxy.

Allan

[JamesV]

E 40 smooth-on epoxy

[Roger Norris]

JB Weld is my choice

[LookMomNoSights]

24 hr 2 part epoxy!

[Plumber]

J B weld, you will NEVER have any problems, an that is what your lookin for

[SlowBowinMO]

I use our low temp hot melt, Super 735, on my personal arrows as I like to move things around a lot.  For customers we use epoxy gel for a more permanent bond.

[JamesKerr]

I like using Easton's hot melt glue.

[Tajue17]

if I'm positive I will never have to seperate them I like 5-minute epoxy because I have plenty of time to get them spinning perfect before they set-up..  hot melt I'll use in a pinch or if I know I'll need to remove the inserts at some point..

[JimB]

I have settled on a gel type epoxy called Epo Grip Fastset.It sets in about 6-8 minutes an isn't your daddy's fastset epoxy.It is tough.I use it for installing inserts,adapters and footings.It gives me plenty of time to align everything but I don't have to baby it after a few minutes.I also find a ton of other uses for it in the shop.I get it from taxidermy suppliers.

[Ringneck]

J-B weld here. You can still heat the adapter up with a small torch and remove if needed.

[BUCKY]

JB Weld

[Rob W.]

regular gorilla glue.

[Tajue17]

not sure about the regular gorilla glue but the stuff I used expanded and pushed the broadhead off the ferral a bit and then set-up so all the tips where wobbly even though I spin test before I set a side.  

not sure which stuff I had but be sure