Zwickey 4 Blade

[TaterHill Archer]

I want to set up some Zwickey 4 Blade Broadheads.  However, when I glue one to an adapter, there's glue all in the "hole" where the bleeders are.  What do you do to keep this area clean and without gobs of glue or does it matter?

[Hud]

If you are using wood arrows, Bear made a thin metal tool to clean and cut a slot. If your using aluminum adapters or steel, I would use a thin jig saw blade or hack saw to slot them. Before slotting, put the head on to align it then use a fine tip, or felt tip permanent marker to mark the adapter or wood so you can see the area to cut. If you use hot melt glue, use the Bear tool to clean out the slot. I am not sure what inserts you will be adding, but if the slot is a bit wide, you will need to use a drop of hot melt glue to keep the insert from dropping out.