I have been using my new Eco-Dipper to put my polycrylic coating on a couple of arrow shafts.  I'm new to this.  Brand new.  First arrows new.  



The layer that the dripper puts on the arrow is very thin.  I have multiple coats on (5-7) and the shafts have product on them but they are nowhere near as smooth and protected as my other wooden shafts.  Can the dipper be modified to put a thicker coating on?

Thanks gents,

Mark

I'm not familiar with that dipper, but if it uses a gasket then the gasket hole is too tight. Run an unfinished shaft (wood) through it to cause a little wear/break in.

I tried it with paints and did not care for it at all.