I want to buy the TM receiver for my Bitzenburger fletch jig.  How do you replace the factory receiver with the new one?  Thanks...Mike

On mine (older model--may be different on a new one) there's a screw at the base (where the indexer goes in) on the right lower part.  Not hard to find, just not real obvious.  Loosen it, the old indexer will slide right out and the new one slides in.  Might have to loosen the allen screws on top also (been a while since I've changed one out--don't remember for sure).

It's pretty easy to figure out once you find that one screw though.

Chad

Thanks Chad, I have an older model as well.  I'll check it out later tonight.  Thanks again...Mike