Hello Bow men I am New to bow building did a few long bows but got the itching to build a take down.
Got two risers done and a few limbs. To get to the point. I got most of the work done but don't know where to drill and don't want to mess up all the good work drilling in the wrong spot. what is the most common spec as per hole placement. might have to brake down and buy someones plans/template any help will be appreciated


            Thanks

      The Jammer    

Probably should post this in the bowyers bench forum..... But you can check out these guys and they can help you out. Elmont Bingham is a good guy.

http://www.binghamprojects.com/

cool already did not much as per the dims I am looking for
 

             Thanks

like kirk says- go back to the home page on trad gang- find the bowyers bench- and post it on there- tons of help for that type of question
good luck mate!

cool thanks