I am wanting to make a rd longbow. I have the print for Bingham's, model. Have anyone of you guys made one of these? Their rd is on the same blue print as their std longbow. Any help would be great.
Thanks
Z

I have not but Binghams is well noted for their products. You might want to check out the bowyers bench on this site there is a lot of good people there that will be able to answer for you.

Kennym has a really great way to trace a drawing to a fowm using a router bit. Check out the bowyer page, lots of good folks and help over there. Have fun and keep your form and cuts square so you don't end up with twisted limbs.

Here ya go!


http://www.kennyscustomarchery.com/contact.html