Morrison ILF aluminum 19" set up

lad · January 05, 2013, 02:14:00 PM

Morrison shooters out there. Where should a guy start with main limb bolt set up with medium glass/wood recurve limbs? thanks

Bill Carlsen · January 05, 2013, 03:53:00 PM

What limbs are you shooting?

ron w · January 05, 2013, 10:06:00 PM

I would start light maybe 4 turns out....try it and turn it in if you think you want more. What is the limb poundage, your draw length, and what are you looking for!

January 05, 2013, 10:16:00 PM

Depends on your draw length. If you have a short draw, you'd probably want to get maximum preload; if you're draw is long, you'd probably want minimum preload.

Take your bolts out; screw them back in about 6 full turns, and that'll be very close to minimum preload.

Insert a set of limbs in the riser and screw your bolts all the way down against the limbs. Back off until you can easily remove and reinsert your limbs. That'll be maximum preload.

You need to mindful not to allow any binding of the ILF fittings.

beendare · January 06, 2013, 12:53:00 AM

good advice from Jim.

Also, Brace height makes a big difference on my Morrison- definate sweet spot . You can feel and hear where it is

sloaf · January 06, 2013, 10:49:00 AM

Anyone have any thoughts on insulating a metal riser? I've noticed not only my hand freezing but it pulling heat from my legs while resting in my lap. I ditched my ilf after early season this year. I've heard about tennis wrap anyone try something else?

Morrison ILF aluminum 19" set up

lad

Bill Carlsen

ron w

beendare

sloaf