3Rivers Archery




The Trad Gang Digital Market














Contribute to Trad Gang and Access the Classifieds!

Become a Trad Gang Sponsor!

Traditional Archery for Bowhunters




RIGHT HAND BOWS CLASSIFIEDS

LEFT HAND BOWS CLASSIFIEDS

TRAD GANG CLASSIFIEDS ACCESS


Main Menu

Anybody Using A Hoyt Excel Riser

Started by Bails, June 02, 2011, 04:29:00 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Nala

Dave,

I'm not understanding your post.  Can you explain please?

I am thinking of getting an Excel 21 inch to replace my WARF.  Are the limbs you put on it listed at 35 pounds on a 21 inch riser?  My limbs are listed at 38 pounds for a 25 inch riser and I figure that'll give me a bow that will come in around 42 pounds or so on an Excel.  I don't know what they'll be when fully cranked down.

Nalajr

Zuner

I am planning to use a very similar setup (Hoyt Excel 21") with medium Samick Privilege limbs (that I will paint matt black) for a total length of 64".

They only doubt that I have is that I have a 30" draw length. Will I have a stacking problem?

The alternative that I was thinking was the 64" Samick Journey (Will the stacking be less of a problem in that case?)

Thanks!

nineworlds9

Nice entry level ILF riser and can be an easy shooting very accurate setup, but IMHO a tuning fork with any limbs much over 45#.
52" Texas Recurve
58" Two Tracks Ogemaw
60" Toelke Chinook
62" Tall Tines Stickflinger
64" Big Jim Mountain Monarch
64" Poison Dart LB
66" Wes Wallace Royal
            
Horse Creek TAC, GA
TBOF

nineworlds9

PS:  find a Black Bear WARF...far far superior.  One of the best feeling and shooting ILF risers one could hope for for cheap $.  Throw on a 5" Doinker and you barely need to hold the thing:  balanced like a dream.
52" Texas Recurve
58" Two Tracks Ogemaw
60" Toelke Chinook
62" Tall Tines Stickflinger
64" Big Jim Mountain Monarch
64" Poison Dart LB
66" Wes Wallace Royal
            
Horse Creek TAC, GA
TBOF

Zuner

Thanks, I live outside the US so WARFS are a bit hard to come around.

I am just starting so for the time being I will get the Medium Samick Privilege limbs at 26# (That with the 21" riser and my draw length makes a about a 32-34# bow)

I'll use it for 3D for the time being and then will upgrade the limbs (probably to the carbon ******** at 45#) for hunting.

Thanks again

damascusdave

For hunting I think you will find a shorty plunger to be more practical...full length plungers just seem like they would always be snagging on things...I am going to try one soon with the Para Rest I have on my Hoyt Desperado...I am also considering putting a sight on that bow to increase my effective range a bit

DDave
I set out a while ago to reduce my herd of 40 bows...And I am finally down to 42

jeff w

Zuner,

I draw 30.5" and had a 64" Excel outfit set up for hunting. I did not experience any stacking, and if I recall, I used medium length limbs with the 23" riser for a 64" bow(?--I think that's right).   I thought it was a very good shooting bow, tolerant of arrow spine and much more quiet than I thought it would be.


Contact Us | Trad Gang.com © | User Agreement
Copyright 2003 thru 2025 ~ Trad Gang.com ©