3Rivers Archery




The Trad Gang Digital Market














Contribute to Trad Gang and Access the Classifieds!

Become a Trad Gang Sponsor!

Traditional Archery for Bowhunters




RIGHT HAND BOWS CLASSIFIEDS

LEFT HAND BOWS CLASSIFIEDS

TRAD GANG CLASSIFIEDS ACCESS


Main Menu

quiver

Started by Arrowcraft, October 04, 2016, 01:11:00 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Arrowcraft

I am going to try and hunt with quiver attached to my bow for the first time. I was always told that the extra weight , coupled with the extra flash of the arrows in a tree was not desirable. I see that the majority of trad guys hunt with a quiver attached to the bow, and that i should practice with it attached, problem is after a dozen or so practice shots broadheads are slipping down from quiver sheath.Does any any one know how I might resolve this arrow slide?
      Black Wolf 68"57#@28-----
-------Tall Tines 60"52&45#@28"----

Shadowhnter


double eagle

I don't use any mounted quiver, just a catquiver or side quiver.  I think you will find a 50/50 split on shooting with it on or off.

Marc B.

Are you using carbons in a large gripper designed for wood?

Longtoke

Could be a few things, if quiver is a bit loose the vibration could be working your arrows out, maybe gripper is too big like mentioned above, other than that the first thing that comes to mind is your foam is worn out around your BH but since you said its a new quiver, not likely.

Picture or knowing what quiver would help

Arrowcraft

I have a thunderhorn small boa 4 arrows I cary 3
  My arrows are carbon express Heritage 150s with a .500 spine and shooting a TallTine 45# @28


---------Black Wolf 68"57#@28-----
----------TallTine   60" 52&45#@28"----

elkken

With that set up extra weight should be minimal ... be sure you are pushing your BH's far enough into the foam and check the fit of the rubber grippers. CE are 5/16" and if you had grippers for wood arrows they could be too big. If your quiver is a strap on model be sure it is attached tight to the bow, if a bolt on be sure your angles for the top and bottom are correct and inline ....

Good luck
Sometimes it's better to be lucky than good

TGMM Family of the Bow

Orion

If the grippers are too big, you can remedy the situation by weaving a rubber band from one opening to the next.  Or, might buy some small rubber O rings at the hardware store and slip them over the gripper nubs, one per arrow opening.

Arrowcraft

Thank everyone for your feedback greatly appreciated !

   --------Black Wolf 68" 57#@28"-------
  ---------TallTines  60" 52&45#@28"-----


Contact Us | Trad Gang.com © | User Agreement
Copyright 2003 thru 2025 ~ Trad Gang.com ©