Thanks and sale at Badger Broadheads

Tee Bone · January 19, 2016, 07:03:00 AM

Just finished up our 3rd year and am thankful for all the support from Trad Gangers. This truly is a great place.
I am overstocked on left wing Badgers so in an attempt to equal out the inventory I am having a sell on left wing only. $38 per pack shipping to the lower 48 included. The only way to get this is to call Jennifer at 706-781-2888. Thanks again.

charles m · January 26, 2016, 12:33:00 PM

I have a hard time tearing one up. Put just a slight tanto on the tip(don't like large tanto tips) and dang amighty these things are tuff!

Jerry Russell · January 26, 2016, 12:39:00 PM

The A-10 Warthog of all broadheads.

Terry Green · January 28, 2016, 12:29:00 PM

My 1st Experience with them...

From the Bottom Up...

Jabar · January 29, 2016, 11:12:00 AM

Now here's a head I have yet to 'fold up' or destroy!!!

Kingstaken · January 29, 2016, 04:53:00 PM

Have an issue with your website fully loading for the past 4 hours.

Terry Green · January 29, 2016, 09:41:00 PM

kings....must be issue on your end as I just downloaded every page of their website at about 1.5 seconds per page on my phone

Kingstaken · January 29, 2016, 10:20:00 PM

Both home and office PC had same issue.

Tee Bone · January 30, 2016, 04:48:00 AM

Sorry about the website issues, I know it is undergoing some changes over the next few days so hopefully it will get straitened out.

Jack Hoyt 75 · October 16, 2016, 10:48:00 PM

I think they are a tough beoadhead but i made the mistake tonight of shooting one into a firm broadhead Yellow Jacket target. Went to pull it out, gave a firm but normal pull and pop the factory insert popped right out. I was suprised how little glue was on it. Not i have to loose a good beoadhead or cut up a good target to get it back. Bummer

shankspony · October 16, 2016, 11:15:00 PM

Yep, great heads. Always have a few in my quiver. Big Plus that I can get them in NZ as well.

RC · October 17, 2016, 03:47:00 AM

RC · October 17, 2016, 03:48:00 AM

RC · October 17, 2016, 03:49:00 AM

RC · October 17, 2016, 03:50:00 AM

RC · October 17, 2016, 03:51:00 AM

RC · October 17, 2016, 03:52:00 AM

RC · October 17, 2016, 03:53:00 AM

Schmidty3 · October 17, 2016, 09:01:00 PM

Mr jack Hoyt,

I don't know if it would work with the yellow jacket sense its so thick...

But what my mind could come up with on the spot when I had a head pop off may help!!!

If you know where the hole is, then put your shaft into the the hole, push the shaft to the point, and push the point out of the back of the target.

But it may not work with a yellow jacket, those things are pretty thick and tough.

October 17, 2016, 11:48:00 PM

RC, you are a killer!!!!!

Bisch