What should I do with these?

[oldbohntr]

What should I do with these?  OK, OK, I know some of you might have a suggestion about that!  But, I'm looking for some help determining if these could be used in an ILF type setup(which I know nothing about!).
 
There are 4 sets of new Martin Archery Quest recurve limbs that I was told should fit any Martin riser with ball bearing pivots in them(Warthogs, others?)   I don't know about risers from other mfgrs.   The ball bearing seats on these look to be 7/8" between centers.  
There are two sets of white limbs, labeled 50 and 30#, 66 & 68", respectively.   Also, two sets of silver limbs, labeled 48# @ 29 and 42.5 @ 28', both labeled 68".   Of course the specs would depend on the riser they are mated to.    I'd think there is the potential to make 4 pretty decent bows, but I don't really know what else is needed. I don't want to spend time and $ looking for old risers that MIGHT fit!  Any help would be appreciated.

[Bowmag]

That's what my old Martin Lynx looks like. But's only a 60" I think. I notice on these that the slots are two different widths. I think the Lynx uses the narrow slots but I would have to check when I get home.

[Sharpend60]

Ive got an  old Hatfild that uses that limb attachment. They arnt too hard to find.

As far as ILF, I have no idea

[oldbohntr]

Thanks, guys.  I suspect these wouldn't work in a true ILF setup, but am looking for some use for them. I guess I'll just have to keep my eyes open until I find something that looks similar.

Yeah, there were probably a lot of Hatfields made, but finding several at reasonable cost might be a trick...

[oldbohntr]

TTT

[damascusdave]

I had a 62 inch Martin Lynx and I am pretty sure they were made 66 inches as well...I would guess you could find either the Lynx compound or recurve riser...I think they are the same

[dhermon85]

I have a Martin Cougar Magnum compound that looks like they may match...