Mods to fit Axis arrows in Selway quiver? Problem solved!!

[8leg-lover]

Has anyone figured out a way to modify the lower rubber arrow clip on a Selway quiver to hold Axis arrows? Any ideas?

Thanks

[Razorbak]

they make a gripper to fit the axis ..in the past i used rubber bands to fit the groove and sometimes add some electrical tape

[8leg-lover]

I didn't see one specified on their site. I'll call them direct.

Thanks

[ishoot4thrills]

Use the lower gripper in the pic below. It worked fine with my Beman MFX Classics, which are the same dia.

[cch]

What I do is just bend the whole lower part out and up. My wife has the limb bolt model and I did this and it holds her tiny arrows that are smaller diameter than the axis.

[Tyler C. Moore]

i agree with ishoot4thrills. If you can find any old compound quiver they usually fit axis and you can just slide the new gripper on your selway. I have three set up like that for MFX's.

[Bill Carlsen]

I believe Thunderhorn archery sells little rubber  band thingies called "snuggies" that are cheap and do the job. Don't have contact info but you can Google them. I got some from them in 2 days and it cost me less than $5 for a quiver I traded for.

[ken denton]

Judt buy some surgical tubing at the drug store ans cut them 1/4" and slip them on each arrow holder. Ken

[sticbow]

take your arrow holder to the hardware store an find the correct size rubber o ring to roll over the rubber arrow gripper if your holder only holds 4 arrows you will only need 4 o rings i shoot the Fmj's an it works great an you can just roll them off if you need to..
                                   Scott

[8leg-lover]

I called Selway today. They had them. Thanks for all the input guys!