Footing sizes for the Ted Nugent Gold Tips?

[J. Cook]

Guys - what aluminum footing is the right size for the Ted Nugent Gold Tips (3555)?  I think the color wrap must be thicker than the traditional wrap.  

2117 is too small - 2216 is too loose.

[Rock 'N Bow]

2219 should fit just right.

[Caughtandhobble]

The 3555 trads take a 2117 footing. You may need to take a drill bit (without the drill) and ream the 2117. I bet it will work fine, the footing seems to get crimped while cutting. Good Luck!!!

Ben

[J. Cook]

I've used the 2117's on the Trad GT's, but the decal wrapping seems to be thicker on the Nugent's.  I could sand it down or ream out the 2117, but was hoping a different size would give a better fit.  

I don't have any 2219's though, so I may try and mess with the 2117's.  I have lots of those, lot's of 2215 and 2216 shaft pieces - it figures I'd need something other than what I have.  LOL

  :rolleyes:

[M60gunner]

I seem to have your same issue. Last GT Trads would not take my 2117 shaft pieces. I have a wide assortment of old shafts to use. My "old age syndrome " kicked in after I was done. Did not write down what worked? I do believe the graphics thickness varies from lot to lot based on what footings are needed.