String ASL

Tradtical Commando · May 30, 2014, 08:15:00 PM

How do you measure a strings ASL???

PaulDeadringer29 · May 30, 2014, 08:22:00 PM

Hang your string from a nail, pull it tight, and measure end to end.

Tradtical Commando · May 30, 2014, 08:36:00 PM

Can you measure it on the bow? Is it from the outside tips of the loops?

Prairie Drifter · May 30, 2014, 08:50:00 PM

yes, I measure with the bow strung to my preferred brace height.

Tradtical Commando · May 30, 2014, 09:09:00 PM

Ok thanks. Just so I am clear, from the string grooves, top of the loop, or the "y" where the loop meets the string?

PaulDeadringer29 · May 30, 2014, 09:20:00 PM

From my understanding, you find what brace height your bow prefers best. Once established, take the string off, hang one end on a nail, and measure from end to end of the string.

Tradtical Commando · May 30, 2014, 09:33:00 PM

Ok that's what I was looking for. Thanks everyone.

PaulDeadringer29 · May 30, 2014, 09:38:00 PM

That's how I have always sent my order in for a string, when asked for an ASL. Good luck!

cahaba · May 30, 2014, 10:08:00 PM

The strings I order from SBD have been measured on my braced bows. I measured to the very end of the loop. They have all fit perfectly. I guess you can do it either way.

Prairie Drifter · May 30, 2014, 10:17:00 PM

I only measure on the strung bow. You can't get as much pressure on the string just pulling it taunt. Strings can have varying amounts of stretch , especially Dacron. I've seen Dacron contract over an inch once it's removed from the bow.

PaulDeadringer29 · May 30, 2014, 10:29:00 PM

I feel like I can never get an accurate enough measurement when measuring the string on a braced recurve.

Prairie Drifter · May 30, 2014, 10:51:00 PM

QuoteOriginally posted by PaulDeadringer29:
I feel like I can never get an accurate enough measurement when measuring the string on a braced recurve.

Paul,
I use a soft tape. Lay at the top of the loop, follow the curve, down the string to the other curve, to the top of the other loop. Works for me.

PaulDeadringer29 · May 31, 2014, 06:14:00 AM

Well, that may be how I start doing it too.

A.S. · May 31, 2014, 06:39:00 AM

Ask your string builder before ordering which way they prefer.

I ask my customers to give me the string length measured OFF the bow (as described above). That way there is no confusion.

SlowBowinMO · May 31, 2014, 07:59:00 AM

QuoteOriginally posted by A.S.:
Ask your string builder before ordering which way they prefer.

I ask my customers to give me the string length measured OFF the bow (as described above). That way there is no confusion.

Me too. For whatever reason we seem to get more improper string measurements when customers measure the string on the bow.