what saw to cut carbon shafts

[Jhawk]

Just orderded some carbons and will need to size them down. What do you all use to cut your carbon shafts. I have a miter saw and wondering if there is a good blade I could get to cut the shafts. For your suggestions, economical is good.

[smokin feathers]

you need to cut carbons with a high speed saw. Where you at in tx, if your close i will cut them for you. you try to cut them with a handsaw and you make splinters in the shafts. if your not close you can make you a little jig or measure the arrow and put in vise and use a dremmel. I have a bowshop so its easy!!

[Jhawk]

Im in Burleson, just south of Ft Worth

[Possum Head]

Yes a dremmel or a 3 to 4" grinder with thin blade.

[Possum Head]

To answer the second question,I have no knowledge of a blade that would work in your miter saw and believe it doesn't turn with sufficient rpms.As a side note be sure you exhaust all your tip and insert weight combinations before cutting up your new order of shafts. Just recently I've been leaving mine full length with 225gr. up front and am delighted with the performance. Just a suggestion.

[Spectre]

Dremel Multi-Max vibratory saw. Its the bomb.

[mahantango]

I use an abrasive cut-off blade or Carborundum blade in a power miter saw. Works fine, just watch the dust.

[D]

I've used a metel chop saw before.  Looks like a miter saw but its for cutting metel pipe and stuff.

[flippnsticks]

Originally posted by Spectre:
Dremel Multi-Max vibratory saw. Its the bomb.

X2  

[8leg-lover]

X3 on the Dremel

[michbowhunter]

I have used this saw from harbor frieght for years and years...works great with the abrasive blade.

http://www.harborfreight.com/bench-top-cut-off-saw-42307.html

[BOWMARKS]

Originally posted by michbowhunter:
I have used this saw from harbor frieght for years and years...works great with the abrasive blade.

 http://www.harborfreight.com/bench-top-cut-off-saw-42307.html  

X2 on this

[Good Stuff]

Originally posted by michbowhunter:
I have used this saw from harbor frieght for years and years...works great with the abrasive blade.

 http://www.harborfreight.com/bench-top-cut-off-saw-42307.html  

x3

[KSdan]

x4 HB

[Stump73]

I made an arrow saw using a dremmel clamped down on a bench. I got the plans from a thread here on Tradgang.