5/16th shafts

[Cane Knife]

I want to use 125G or a little higher Braodheads on 5/16" cegar shafts.  I can only find 110g Zwickeys.  Do you think it would be fine to glue 11/32" heads on the 5/16" shafts?

[freeman]

You could grind a little off the base of the ferrule and turn them into 5/16 heads.

[ChuckC]

They should glue on fine. They will, of course be a tad bigger than your shaft, but that could cause less friction maybe ?  I have full size broadheads on screw in adapters for my narrow carbons and they shoot fine.

ChuckC

[Bjorn]

No problem.

[Lee Robinson .]

People have done that for decades without any problems.

[Stone Knife]

I have done it with no problems, they are just a little harder to get to line up straight.

[Tom Phillips]

Some HEAD-SHRINKERS that were made back in the day for Original FORGEWOOD shafts that were made in a handful of Sizes would work great if you can find some !!!! Only 1 size Head-Shrinker as far as I know fit all the Forgewoods.

[john fletch]

I would like to see a picture of those 5/16" 'cegar' shafts !

[Cane Knife]

"CEGAR SHAFTS" Didn't you hear?  It's the newest thing out...you roll your own!  LOL

[term]

It will work fine. As said above it will help penetration. TERM

[B/W lvr]

No problem at all actually its a plus as it will increase penetration. Frank