Saunders PAK TAB Question....

[Nala]

Hey all,

I am thinking about trying one of the Pak Tabs and noticed something on it that I wanted to ask about before I bought one.

I have been looking at some pics that showed the backside and the bolts that the screws go into look like they stick up quite a bit.  From what I seen it looked like that would be pretty darn uncomfortable.  I don't think I'd want those 2 bolts sticking into my fingers as I was under full draw.

Am I seeing something that isn't there or did I just happen upon a bad picture?  Do those bolts really stick out that much?

Thoughts?

Thanks for the time.

Nalajr

[Steve Leffler]

The bolts you are talking about are actually pins  to allow a finger spacer to be pushed on.  When the spacer is on the pins are covered.  If you don't use a spacer the pins actually pop out.  I love Pak tabs and use them all the time.

[Pierre Lucas]

No problems with the Pak Tabs.  You can customize them for feel and to be really quiet.  

Pak tabs don't wear out either, they get better with age.  

Know a friend who has been using the same one for seven years and it is finally tearing.  He is the one that turned me on to them...

God bless,  Pierre

[BowMIke]

I take them apart and trim down to minimum needed to cover fingertips. Don't use any of the padding or spacers.I like them a lot. Just spin them around on your finger to get them out of the way.

[R.W.]

Never had a problem with the pins/screws causing any discomfort.

And, you can set the tab up how you prefer your tab to be. Thin, thick or anywhere in between.

With or without the anti-pinch spacer.

And, as mentioned above, these things wear like iron!

I still have my original Saunders tab, and though it is getting a little ratty, it still does the job, and does it well.

But, I bought six more, just to sure that I always have a "spare."