How to get factory insert out of a WW?

[MikeW]

Anyone done this? I'd like to take the factory insert out of some Woodsmen's I have. What are they in there with? Epoxy?
TIA

[Smallwood]

it's mounted with an industrial epoxy like jb weld, just heat and pull, heat and pull, till it breaks loose.

[James Wrenn]

They will come out with a little heat like said.

[MikeW]

Thx guys..I'll give it a try.

[J-dog]

you might try boiling them instead of a direct heat though I am not sure this will work with epoxy?

J

[O.L. Adcock]

Naw, the boiling doesn't get hot enough. Heat the insert only and have big pliers on the head to act as a heat sink. Got to be careful not to over heat the broadhead steel or you'll ruin it's temper and lose yours!   ....O.L.

[fredbear1969]

i heated some and the broadhead shot off and landed on my bow stringer needless to say it burnt my stringer intwain.but when ya heat them up have it pointed in a safe direction