Where to get 1 aluminum shaft for footing Axis carbons and .340 size?

[Tedd]

What size aluminum shaft to foot a .340 Axis Trad? 2016? And where do you get 1 shaft?

Anyone use the Sapcut Arra Foots? I can't tell what # I would need.
Thanks,

[Longtoke]

I think the outside diameter of the 340 axis trad is  0.2700

so then I think a 2016 shaft would work well.  Finding lone shafts can be tricky but the 2016 is pretty common and should not be hard.

First thing I would check out rocky mountain specialty gear and their used arrow bin, call them up on the phone, I bet they got a lone shaft for you.

 I think lancaster sells single shafts too.

[Jakeemt]

Pm me I have a a few bent 2016,2117, and 2216 if on of those sizes will fit I'll send it to you

[Tedd]

Thank you. But I found a shaft that fits in my old stock. I think it's a 2016 but I cap dipped over the size. It fits and looks fine. I used a 1" footing. Should make a tough shaft.

[iohkus]

Lancaster sells single shafts. If the 340 IS .270 O.D. then a 2018 would be ideal, being .2765 I.D.