Author Topic: JB-weld  (Read 405 times)

Online Kopper1013

  • Trad Bowhunter
  • **
  • Posts: 1546
JB-weld
« on: February 15, 2019, 04:59:04 PM »
Any one using 5min clear JB-weld for nock overlays?

Claims 4,400psi tensile strength which is 1,000psi more than smooth-0n ea-40...

Wondering if anyone has any experience using it or reasons why I shouldn’t?
Primitive archery gives yourself the maximum challenge while giving the animal the maximum chance to escape- G. Fred Asbell

Online Crooked Stic

  • Trad Bowhunter
  • **
  • Posts: 3316
Re: JB-weld
« Reply #1 on: February 15, 2019, 07:53:14 PM »
Never knew there was such a thing. Should work though.
High on Archery.

Online Flem

  • Trad Bowhunter
  • **
  • Posts: 881
Re: JB-weld
« Reply #2 on: February 15, 2019, 07:53:54 PM »
Never used it for any bow related projects, but used it on plenty of other things. Its good stuff, can't imagine it would not work well for any non flexing app. And it matches my attention span :bigsmyl:

Online Kopper1013

  • Trad Bowhunter
  • **
  • Posts: 1546
Re: JB-weld
« Reply #3 on: February 15, 2019, 08:41:59 PM »
Exactly my thinking flem!

no flex in the tips, said it’s good to 500 degrees for 10 min and completely water resistant :dunno: so I just glued them up, worst case they pop or I grind them off if I don’t like it for some reason right?
Primitive archery gives yourself the maximum challenge while giving the animal the maximum chance to escape- G. Fred Asbell

Online Forwardhandle

  • Trad Bowhunter
  • **
  • Posts: 1534
Re: JB-weld
« Reply #4 on: February 16, 2019, 01:54:04 PM »
I think you will be fine I use it all the time to repair pin holes on pneumatic bulker tanks it holds 20 psi presure & 200 Deg F fine,  fixed pipes with to ,it's good stuff takes heat well solid stuff !
If you fear failure, you will never try ! But never except it!!

Users currently browsing this topic:

0 Members and 1 Guest are viewing this topic.
 

Contact Us | Trad Gang.com © | User Agreement

Copyright 2003 thru 2019 ~ Trad Gang.com ©