Text only | Text with Images

Trad Gang

Main Boards => PowWow => Topic started by: snag on October 11, 2007, 04:37:00 PM

Title: Tapered Shafts
Post by: snag on October 11, 2007, 04:37:00 PM
Just picked up some POC tapered shafts. They are 5/16" on the nock end. Is there anything different involved in fletching these because of the different diameter and tapering? I use a JoJann fletcher.
Title: Re: Tapered Shafts
Post by: Golden Hawk on October 11, 2007, 04:38:00 PM
No but you'll most likely have to reset your jig because of the taper.
Title: Re: Tapered Shafts
Post by: Jwilliam on October 11, 2007, 04:40:00 PM
I don't do anything different. Fletch just the same as all my other arrows.

Bill
Title: Re: Tapered Shafts
Post by: Big Dave on October 11, 2007, 04:41:00 PM
Same way
Title: Re: Tapered Shafts
Post by: Bjorn on October 11, 2007, 07:03:00 PM
Nice avatar! Do them the same.
Title: Re: Tapered Shafts
Post by: hawksnest on October 11, 2007, 07:14:00 PM
QuoteOriginally posted by snag:
Just picked up some POC tapered shafts. They are 5/16" on the nock end. Is there anything different involved in fletching these because of the different diameter and tapering? I use a JoJann fletcher.
My Jo Jan does them with the same settings as parallel shafts.  Bill G.
Text only | Text with Images