Trad Gang

Main Boards => PowWow => Topic started by: Bullfrog 1 on April 25, 2015, 09:14:00 PM

Title: Preferred fetching glue for carbon?
Post by: Bullfrog 1 on April 25, 2015, 09:14:00 PM
What do you guys like?  I usually use fletch title platinum. Thanks. Bill
Title: Re: Preferred fetching glue for carbon?
Post by: jamesh76 on April 25, 2015, 09:31:00 PM
I really like using wraps and fletch tape + superglue gel. Or just superglue gel.   I always use wraps because it makes re fletching easier.
Title: Re: Preferred fetching glue for carbon?
Post by: M60gunner on April 25, 2015, 09:38:00 PM
There is a thread about issues using Fletch tite Plat on bare carbon. I know I was one. I went with Saunders NPV glue. Others liked the fletch tape, others various super glues. I would only use the Fletch Tite if you use wraps or cap dip with Fletch Lac paints. Prep is very important no matter what glue or tape you choose. I tend to go overboard on the bare shaft, I use acetone and 0000 steel wool. I also do this to remove the shaft makers info.
Title: Re: Preferred fetching glue for carbon?
Post by: karrow on April 25, 2015, 09:49:00 PM
super glue
Title: Re: Preferred fetching glue for carbon?
Post by: JamesV on April 25, 2015, 09:49:00 PM
I spray my carbons with Bull Dog adhesive promoter before fletching. Use duco and never have a problem.

James
Title: Re: Preferred fetching glue for carbon?
Post by: Jon Stewart on April 25, 2015, 10:05:00 PM
Locktite Ultra gel super glue.
Title: Re: Preferred fetching glue for carbon?
Post by: Jack Hoyt 75 on April 25, 2015, 10:57:00 PM
I have used several.  Bob Smith Industries is the best IMO.  Can order online.  Very strong and dries fast.
Title: Re: Preferred fetching glue for carbon?
Post by: Iowabowhunter on April 25, 2015, 11:01:00 PM
I use Fast Set gel, really like it
Title: Re: Preferred fetching glue for carbon?
Post by: JRY309 on April 25, 2015, 11:39:00 PM
I always use wraps on my carbon arrows and use Platinum fletch tite for gluing.Holds great and haven't had any problem.Never like gluing to a carbon shaft.Using wraps makes them so much easier to redo later if needed.Carbons are tough arrows and chances are if you don't loose them you will be redoing them later.
Title: Re: Preferred fetching glue for carbon?
Post by: **DONOTDELETE** on April 26, 2015, 01:00:00 AM
I prefer wraps on my carbon shafts typically, but even gluing right to carbon i like using Goat Tough for fletching over anything else.

http://www.georgesports.com/goat-tuff-high-impact-glue-5oz/?gclid=CjwKEAjw9uypBRD5pMDYtsKxvXcSJACcb9AYSmKtzle3KtEt5XbJUaEksza75xMngwmcGV7YM9CSUBoCfgvw_wcB
Title: Re: Preferred fetching glue for carbon?
Post by: Possum Head on April 26, 2015, 08:26:00 AM
Platinum for me. Never lost a feather to it (bare carbon) but about 1 year inside and shelf life expires.
Title: Re: Preferred fetching glue for carbon?
Post by: Bobby Urban on April 26, 2015, 08:34:00 AM
tape
Title: Re: Preferred fetching glue for carbon?
Post by: Babbling Bob on April 26, 2015, 08:49:00 AM
Saunders NPV for me!
Title: Re: Preferred fetching glue for carbon?
Post by: ISP 5353 on April 26, 2015, 03:13:00 PM
Wraps and Locktite Gel.
Title: Re: Preferred fetching glue for carbon?
Post by: bulldog18 on April 26, 2015, 03:29:00 PM
Gorilla super glue gel
Title: Re: Preferred fetching glue for carbon?
Post by: ranger 3 on April 26, 2015, 07:52:00 PM
Duco
Title: Re: Preferred fetching glue for carbon?
Post by: bowhuntingrn on April 26, 2015, 10:08:00 PM
QuoteOriginally posted by ISP 5353:
Wraps and Locktite Gel.
This^^^
Title: Re: Preferred fetching glue for carbon?
Post by: on April 26, 2015, 10:23:00 PM
QuoteOriginally posted by Bullfrog 1:
What do you guys like?  I usually use fletch title platinum. Thanks. Bill
Same for me, and I never have feathers come off!

Bisch
Title: Re: Preferred fetching glue for carbon?
Post by: Jakeemt on April 26, 2015, 11:19:00 PM
I like tape with a dab or gorilla super glue on the ends. Works great for me.
Title: Re: Preferred fetching glue for carbon?
Post by: Flying Dogg on April 27, 2015, 12:38:00 PM
Saunders NPV glue.
Title: Re: Preferred fetching glue for carbon?
Post by: the rifleman on April 27, 2015, 06:34:00 PM
JRY309
Contributor 2015
Member # 1191

Icon 1 posted April 25, 2015 11:39 PM      Profile for JRY309   Email JRY309   Send New Private Message       Edit/Delete
Post   Reply With Quote
I always use wraps on my carbon arrows and use Platinum fletch tite for gluing.Holds great and haven't had any problem.Never like gluing to a carbon shaft.Using wraps makes them so much easier to redo later if needed.Carbons are tough arrows and chances are if you don't loose them you will be redoing them later.
Posts: 5863 | From: ohio | Registered: Jun 2003  |  IP: Logged | Report this post to a Moderator
I agree-- try Onestringer wraps and like possum head said replace with a fresh tube once every 12 months.  Dot of glue front and back of each feather completes the job.
Title: Re: Preferred fetching glue for carbon?
Post by: Cootling on April 27, 2015, 09:45:00 PM
LocTite ultra control gel.  Great stuff.
Title: Re: Preferred fetching glue for carbon?
Post by: Redux on April 27, 2015, 10:10:00 PM
I just started fletching my own, but the tape seems to work well for me! Dab of superglue on both ends and I have yet to have an issue.
Title: Re: Preferred fetching glue for carbon?
Post by: yeager on April 28, 2015, 10:55:00 AM
Another for Fast-Set Gel. Have been using this exclusively for years.
Title: Re: Preferred fetching glue for carbon?
Post by: Gooserbat on May 29, 2015, 09:33:00 PM
QuoteOriginally posted by bulldog18:
Gorilla super glue gel
This
Title: Re: Preferred fetching glue for carbon?
Post by: trad_bowhunter1965 on May 30, 2015, 11:54:00 AM
Bohning Fletch tape.
Title: Re: Preferred fetching glue for carbon?
Post by: cacciatore on May 30, 2015, 12:09:00 PM
Fletch Tite Platinum,never lost a feather,I have the opposite issue,when they are glued no way to replace a damaged feather.
Title: Re: Preferred fetching glue for carbon?
Post by: stagetek on May 30, 2015, 12:10:00 PM
I've used Fletch-tite for years without issues but, recently tried Saunders NPV. I like it. It seems to flow out of the tube easier and more even.
Title: Re: Preferred fetching glue for carbon?
Post by: reddogge on May 30, 2015, 02:34:00 PM
Saunders NPV.
Title: Re: Preferred fetching glue for carbon?
Post by: Wheels2 on May 30, 2015, 06:23:00 PM
Saunders NPV.  Does not become brittle and fletching is easily scraped off without the chipping like super glues.
Title: Re: Preferred fetching glue for carbon?
Post by: LookMomNoSights on May 30, 2015, 07:02:00 PM
Platinum user here........