Trad Gang
Main Boards => PowWow => Topic started by: Roy from Pa on January 22, 2007, 05:42:00 PM
-
Started another osage backed with boo.
(http://www.geocities.com/roy2953/abow20073.jpg)
(http://www.geocities.com/roy2953/abow2007001.jpg)
(http://www.geocities.com/roy2953/abow2007002.jpg)
(http://www.geocities.com/roy2953/abow2007003.jpg)
(http://www.geocities.com/roy2953/abow2007007.jpg)
-
Looking good man,
-
Nice job Roy, say is that your bath tub in the second picture??? :bigsmyl:
-
Well Dano, it almost has been a couple times:)
-
:biglaugh:
-
Hey Roy, I used your dimensions from your build along to glue up a Hickory backed Ipe. She came out of the clamps this morning lookin sweet. Thanks for sharin your knowledge to us bowyer wannabes. :bigsmyl:
-
You bet Kenny. This bow is for my wife, so I went with the target bow measurements for the mid limb posts. Except, I moved them in closer to the riser by 1 inch from the 16 for the top and 15 5/8th for the bottom of a normal setup. So on this bow the top mid limb post is set at 15 inches and the bottom mid limb post is set at 14 5/8th from the center of the handle. The limb tip posts I increased by 1/2 inch on this bow, from 6 to 6 1/2. She came out of the clamps with 3 1/4 reflex at the tips.
I intend to take the limb tips down to 1/2 wide and my draw weight target is 30 to 35 pounds. The wife was is a wreck years ago and has a problem with her shoulder on her drawing arm, so she can't handle much more than 35 pounds without causing her pain..
-
Nice bow and nice house!
-
Cut her out today and have it on the tillering tree. Looks very good so far.
(http://www.geocities.com/roy2953/abow20070011.jpg)
(http://www.geocities.com/roy2953/abow20070012.jpg)
(http://www.geocities.com/roy2953/abow20070013.jpg)
(http://www.geocities.com/roy2953/abow20070014.jpg)
(http://www.geocities.com/roy2953/abow20070015.jpg)