Print Page - Footing 300 Spine ACC-Hunting Shafts

Title: Footing 300 Spine ACC-Hunting Shafts
Post by: doeboy on September 02, 2014, 01:15:00 PM

Guys,

Can someone help out with some info on what size aluminum arrow i will need to foot these arrows mentioned above? I read that they are 9/32 O.D. I was not able to find any info on-line. Thanks for the help.

Red

Title: Re: Footing 300 Spine ACC-Hunting Shafts
Post by: JimB on September 02, 2014, 02:58:00 PM

Often,designations like 9/32",5/16" are just approximate.You will need to measure or have someone measure one for the exact outside dimension.After that,it is easy to select an aluminum shaft.

Title: Re: Footing 300 Spine ACC-Hunting Shafts
Post by: willyr1 on September 02, 2014, 03:04:00 PM

I have seen a chart showing what carbon arrow neeeds what alloy arrow for a footing. But I can't find it again. It was posted on here somewhere. I want to foot my 5575 gt and can't find the right alloy arrow. I know 3555 takes a 2117 alloy arrow.

Title: Re: Footing 300 Spine ACC-Hunting Shafts
Post by: willyr1 on September 02, 2014, 03:05:00 PM

Title: Re: Footing 300 Spine ACC-Hunting Shafts
Post by: JimB on September 02, 2014, 03:17:00 PM

OK Doeboy,that .300 is supposed to be .284 OD..A 2013 is .2865 ID,2012 is .2885 ID and 2117 is .2941.Any of those should work.The 2117 would be a little loose but a paste epoxy or a urethane glue should make that work.

willyr1,same thing,look up the OD of your shaft.Remember,wood grain are slightly bigger than black.
(http://i10.photobucket.com/albums/a140/jbrandenburg/scan-22.jpg) (http://s10.photobucket.com/user/jbrandenburg/media/scan-22.jpg.html)

Title: Re: Footing 300 Spine ACC-Hunting Shafts
Post by: doeboy on September 02, 2014, 11:01:00 PM

Thanks for all the replys guys

Trad Gang

Main Boards => PowWow => Topic started by: doeboy on September 02, 2014, 01:15:00 PM