Trad Gang

Main Boards => PowWow => Topic started by: hawk22 on August 31, 2014, 05:50:00 PM

Title: GT kinetic hunter 400 footing
Post by: hawk22 on August 31, 2014, 05:50:00 PM

Anyone know what size aluminum shaft works for footing the gt kinetic hunter 400?

Title: Re: GT kinetic hunter 400 footing
Post by: old_goat2 on August 31, 2014, 07:55:00 PM

2020 fits perfect on the tip end and was just ever so slightly loose on the nock end but so far they haven't broke loose. I did one inch pieces on the tip and I believe they were in the 15-16 gr range and did 1/4" on the nock ends at around 4gr. Used JB Weld and it has held up to some crazy hard hits!

Title: Re: GT kinetic hunter 400 footing
Post by: hawk22 on August 31, 2014, 10:45:00 PM

Did you cover the insert too or just the end of the arrow itself?

Title: Re: GT kinetic hunter 400 footing
Post by: willyr1 on September 01, 2014, 05:09:00 AM

Is it the same aluminum arrow (2020) for 5575 exp hunter.

Title: Re: GT kinetic hunter 400 footing
Post by: old_goat2 on September 07, 2014, 06:38:00 PM

Sorry, been elk hunting and YES cover the outsert! It's the weak link for this arrow. Willy no it won't work on those, kinetic is a small diameter arrow.