Trad Gang
Main Boards => PowWow => Topic started by: Tradtical Commando on May 29, 2014, 09:12:00 PM
-
I found the snakeskin how-to and want to do one of my bows, BUT I am not sure how to get from whole snakes in my freezer, to the beginning of the how-to thread. Obviously I skin it out, but is there any other prep or do I just dry the skin out and start at the beginning of the thread? By dry out I mean tack to a board and leave it there a few days. Do I need to put any kind of solution on it or anything? Scale removal? etc etc
All info is appreciated!
-
Tack to a board skin side up and let dry. Don't put anything on it. You remove the scales after you apply it to the bow once it is dried before you put finish on it.
-
I'll just add,flesh any meat or fat off.A tablespoon works good for this.Scrape from tail toward head or side to side.Don't dry it in direct sun light.If you have some insulation foam board,you can tack it out with a staple gun very easily.I usually do my incisions with a pair of bandage scissors but a sharp knife will work.
-
You don't have to dry the skin before applying it. You can put it on green. Scrape the fat and excess meat off first like others said. I like to wash skins in Dawn dish soap and warm water before gluing it down. Once washed, size the back of the bow and the skin and put them together. With sharp scissors trim of the excess skin along the side but leave them proud until after the glue had dried. If the skin is thin enough you may not need to wrap but with most skins you will have to wrap. I use strips of old bed sheets for this. I leave the wrap on for about an hour so the glue begin to set then remove the wrap and work out any air bubbles and excess glue pockets and be sure the skin is lined up straight down the limb.
Once dry, tomorrow or longer I use a smooth bastard file to trim and dress the edges. Also after it dries you remove the scales and add your favorite finish. I like 5 or 6 coats of Tru-Oil.
My skinning experience is on wood bows only but I don't think it would be much difference for a glass bow.
-
Personally,I wouldn't put a fresh skin on a glass bow.I can put a skin on a board,flesh side up and it will dry in a day.As a taxidermist,when I put one on a manikin with a water based glue underneath,it takes a month to completely dry.The reason is,the epidermis of reptile skin is naturally very well sealed in order top retain moisture.
-
Well Jim, you would know better than me. I've never skinned a glass bow. Thanks for the heads up.
-
Yeah, I was going to say remove all fat/tissue, clean real good with dish soap, let dry, then re- soften with warm water, pat dry and its ready to glue
-
Ok thanks for all the info everyone. Does anyone know what type of glue I would use to attach to carbon arrows for wraps?