Print Page - AD Trad ?

Title: AD Trad ?
Post by: daveycrockett on April 16, 2013, 09:06:00 PM

Ordered some of these today. What are you that use these using to glue the inserts in with?

Title: Re: AD Trad ?
Post by: southpawshooter on April 16, 2013, 09:58:00 PM

JB weld or Gorilla flexible super glue

Title: Re: AD Trad ?
Post by: daveycrockett on April 16, 2013, 10:47:00 PM

QuoteOriginally posted by southpawshooter:
JB weld or Gorilla flexible super glue

Thanks

Title: Re: AD Trad ?
Post by: JRY309 on April 16, 2013, 11:26:00 PM

I just used some AAE 24 hr. epoxy,same as I use on my inserts for carbons.

Title: Re: AD Trad ?
Post by: daveycrockett on April 28, 2013, 01:25:00 PM

Anybody try the blue low heat hot melt? :campfire:

Title: Re: AD Trad ?
Post by: RLA on April 28, 2013, 02:22:00 PM

(Anybody try the blue low heat hot melt? :campfire: )

Yes, that's what I've been using with good results.

Title: Re: AD Trad ?
Post by: TOEJAMMER on April 28, 2013, 02:28:00 PM

Always use the low heat hot melt and have never had an insert pull out.

Title: Re: AD Trad ?
Post by: daveycrockett on April 28, 2013, 02:33:00 PM

Thanks.

Title: Re: AD Trad ?
Post by: JamesKerr on April 28, 2013, 03:36:00 PM

I use Easton's hot melt glue. It holds much better for me than Bohning's hot melt and it melts at a lower temperature.

Title: Re: AD Trad ?
Post by: threeunder on April 28, 2013, 04:01:00 PM

Hot melt for me. Never slipped an insert.

Trad Gang