8 arrow Bear grippers loose for carbons, any suggestions?
Cannot find replacement for this model
Go to Thunderhorn and order some of their snuggers.
OR, just buy your self a tube of Goop. Use a tooth pic to smear a layer around the inside of the arrow pads. I've tightened up two of mine that way.
I usually just use rubber bands intertwined thru the grippers till tight enough.
What macbow said. Works great.
You can place a small screw between the grippers and screw them in to tighten them up.
Bob York used to make custom replacement grippers for 4-arrow and 8-arrow Bear bow quivers. He could custom punch them for whatever size arrow you use.
Anyone out there have contact info?
I could use a couple myself.
Thanks for the help
Thunderhorn is the best answer.
I use heat shrink tubing, cut into small bands , put around gripper and shrink up, sometimes takes a couple but lasts quite awhile
Bike inner tube has worked well for me. Cheap, simple, and effective.
(http://i51.photobucket.com/albums/f361/lefty4/Bear%20Quiver%20Mods%20-%20Inner%20tube/P1010518.jpg)