What is the down side to putting 5/16" nocks on larger aluminum shafts? I have a bunch of old glue-on 5/16" nocks and would use them on some 2419 shafts... but don't want to get into any trouble.
Any counsel from you experienced guys?
[Mods, I looked around for a forum for this, and didn't see one. I won't take it personally if this gets deleted...!]
Those are quite small for a fat shaft, that said it should not hurt a thing. I have shot pin nocks off large shafts. The only problem may be putting pressure on the nock if you shoot 3 under. I always use smaller nocks on my woodies. I use 5/16ths. on 11/32nds. and 23/64ths. woodies. Shawn