Has anyone put a Kwikee Quiver with the quick detach bracket that you mount onto the side of the riser on their trad bow?
I have but use it only to transport my arrows to and from the stand. I eventually removed it because it made noise due to vibration of the metal keeper.
I have one on my K Mag and it works nice . I like to pop it off when I am on stand and it works good on the bow when still hunting .
I used one on my Bear Takedown hunter. I usually shoot with a quiver but the kwikee quiver really threw it off balance.
I use one on my Rocky Mtn Recurve, have since I got the bow back in 1989, same quiver for over 20 years.
(http://i257.photobucket.com/albums/hh236/Prairiedrifter/hunting/rabbit2.jpg)
use the 6 arrow kwikee on my bob lute 1 piece favorite bow and setup quiver is amazing
I really like the Kwikee for use as a detachable quiver. Nothing fancy, but they just work great for stand hunting.
I don't like shooting with them though. Too noisy and "unbalanced".
I have one on several of my bows. Love it when in a ground blind. Pops off easy and makes handling the bow quietly easier. I also use it when hunting from tree stand some times.
Yes, it's a great quiver. Cheap, durable, and light. Detaches easily.
I use one and love it. Quick and easy. Mine is very quiet. I usually take it off the bow if I am in a tree.
I love my Kwickie on my bow I detach whle on stand. Since are bows are not Tapped for it I use the AMS bowfishing attachment to strap it on.
I love the Kwikee Kwiver. To me there's no better way to carry your arrows while hunting. I don't like shooting any bow with a quiver on it so the Kwikee makes it easy to take off when I'm on stand. I use the screw in tree bracket and it holds the arrows tight to the tree. Kustom King carries the inserts (from Martin) that are easy to install. Just be sure you have a good brad point or forstner bit when drilling the holes so they don't tear out.
I have 3 of the 6 arrow and 1 four arrow Kwikee. During hunting season I have arrows that match different bows all ready to go. I just select the bow, take the quiver with the right arows, and off I go. I covered all the quiver hoods in leather. They look great on a trad bow.
For 3D or targets I just use a side or back quiver.
I mounted a quick release to a few of my tree stands that I would attach the quiver to when I got on stand.
I screwed one on to my 68 Kodiak Hunter. Wished I didn't, now I have two holes in the side of my bow. I took the clip off and attached it to a piece of 8 oz leather, made a belt loop on the leather and wear the quickie quiver on my side rather than on my bow. Basically made a side quiver out of it except I can unclip it when I hunting and hang it up or lay it down depending on where I am hunting..
I use a Kwikee Kwiver also. Love`em. I searched around to find one of the older models (one with the running deer logo on the hood) for my recurve. I shoot canted so the bit of weight on the side of the bow naturally leans the bow the way I want anyhow, so it works perfectly for me.
I've done it.
It was ok.
I use a side/back quiver now.
I use a Kwikee Kwiver on my bows alot. I usually do not shoot with it on but use it to transport arrows to my stand where I remove it and then attach it to another bracket that I can screw into the tree. Great way to transport the arrows.