Trad Gang

Main Boards => PowWow => Topic started by: Nala on August 15, 2012, 05:06:00 PM

Title: Shoot ILF Limbs on a Hoyt Dorado...HOW?
Post by: Nala on August 15, 2012, 05:06:00 PM
Hey all,

I have some ILF limbs and been thinking of picking up a riser to use.  I may have a line on a deal for a HOYT DORADO, which is NOT ILF compatible.  I have read and heard of those that are using them with ILF limbs.

Can you all tell me how one would go about using those ILF limbs on a HOYT Dorado (or Gamemaster) riser?  What would I have to buy to do it and how much would it cost?

Thanks for the time.

Nalajr
Title: Re: Shoot ILF Limbs on a Hoyt Dorado...HOW?
Post by: wingnut on August 15, 2012, 05:11:00 PM
You need the Hoyt bushings for the limbs and that's about it.  Press out the ILF fixtures and press in the Hoyt.  Bolt them up and tighten them down.

If you need to adjust tiller you use shims.

Mike
Title: Re: Shoot ILF Limbs on a Hoyt Dorado...HOW?
Post by: el greco on August 15, 2012, 05:15:00 PM
Hey Nala.********-********* archery carries the bushings for the conversion of tour ilf limbs to your dorado-gamemaster riser.Easy
Title: Re: Shoot ILF Limbs on a Hoyt Dorado...HOW?
Post by: M60gunner on August 15, 2012, 06:30:00 PM
Well one day I borrowed a friends Dorado. I used brass tubing that fit inside the limb holes where the ILF stuff is. Worked fine for me. Now I have to remember to put the limbs back to ILF.