I'm looking for a way to chamfer my footings so that they're easier to pull out of targets. I'm also looking for a reamer/deburring tool to clean up the edges/roll on my glue on broadheads so they mate better with the threaded adapter.
Anyone have any idea of a simple hand tool/tools that can accomplish this for me? Links and/or pics would be helpful.
check into reloading sites. they have a tool that may work. i used one from my reloader on aluminum shafts for years
You might do a search. This was just talked about here
http://tradgang.com/noncgi/ultimatebb.php?ubb=get_topic;f=1;t=118156;p=1#000002
yep
check reloading supply cos for an id-od chamfer tool
they work great
On the rear edge of the footing, I take a small file and chamfer at a gentler angle than the case prep tool. I chuck it into a bench- mounted drill, it goes pretty quick.
Killdeer
There is specialty deburring tool called the VLD (Lyman???) that is at a smaller angle than the std one.