Trad Gang
Main Boards => PowWow => Topic started by: Stump Buster on June 02, 2012, 10:40:00 PM
-
Hey Gang,
Tried a search but couldn't narrow anything down, so I figured I'd start a new thread.
For those of you who have one piece longbows 66" and over, how do you transport them safely. Just looking for new ideas.
I'm currently using a hard snow ski/fishing pole case and a case I made out of PVC and endcaps. These work great, but was wondering how else I can fit my bows inside the cab of my truck.
I have a two piece 70" Northern Mist Shelton on order and may change it to a one piece if I can find an easier way to get the bow in the cab of my truck. The connexion t/d system is an awesome design and VERY easy to use, but I find it feels "wierd" and mildly takes away from the overall aesthetics of the american style longbow.
Anyway... Your thoughts are appreciated as always!!!
Stump
-
if going from my home to my hunting spot in my own vehicle...it gets put in front seat..one end on floor the other in passenger seat. May have to lean the seat back but will fit...stick upper limb in first and then place lower into floorboard.
if flying or going long distances...i have a length of PVC tubing with caps..one glued and the other screws on with small hole drilled to let air equalize in pipe.
-
Had a lot of bows but now one piece only. Just too simple w/o worries. Transport in bowsocks stuffed in pvc tubes if I'm going any distance. My bows are all 68" & 70" ntn.
-
Can't beat PVC
-
They're not very handy when it come to traveling. I just use a bow sock and a PVC tube and throw it in the truck. Not too many options.
Eric
-
Yes sir, bow socks and PVC tubes with foam in each end for me. If I'm alone, it goes in the cab of the truck like Brock said. Otherwise it's PVC and in the bed of the truck.
Danny
-
4" PVC, padded cap on the bottom, and threaded plug on the other. I have thought about adding a cover & handle. Be sure to use a bow sock.
-
Bow sock and pvc
-
What they all said...
-
Same as others have said for truck or plane.
However I sometimes travel to range, shoots ,or even hunt locations in the wives Toyota. (Yaris, very small)
When doing this I bungee the bow unstrung to the handles over the the inside of the doors. (back to front, usually on drivers side,where the clothes hanging hooks are on most vehicles) When doing this you can travel, get in and out of the car, and never know the bows are there. Had 3 adults and 1 child in car on last trip. With three bows in this location we traveled 240 miles 1 way and nobody even took notice to the bows being in the car.
-
Couldn't do that in the Tundra!
I put one end of my Northern Mist in the front right floorboard and the other between the front seats, over the console and into the back. If I did not have the access cab then it would have to stick out the back window!
Killdeer
-
Great question... for my bow I figured i needed 6"diameter tube for padding room. Looked at PHF tubes... wow, heavy! But I wanted it primarily for back of truck going to camp. I did find a fishingtrip pole tube,6", called the bazooka. Its awesome! Has handle, was light, comes in different diameters. Just couldn't talk myself into paying the $70. What I found and use in the back of my truck under my fiberglass bed cover is a 6"diameter × 6' long drainage pipe. Black plastic ribbed on outside, smooth on inside, made of two layers. Its super light. I was worried about vibration rubbing my bow.on long trips so I created a super bow.sock out of a queen sized green fleece blanket folded in half, my precious cascade rolled into the center of 6" of padding! Lol this slips firmly into my tube. The tube is tied to the truck bed corner tie off loops front and back. My gear for hunting camp packs around or overthe whatever! No fear of my treestand orshifting gear shifting and rubbing or hitting my long bow. :) makes my brother laugh... he uses a bow.sock :)
-
Pvc and sock. I have a padded camper kit in my Toyo and forlocal jaunts she lays on the carpet back there. Forcamping, always in the tube. I never propher upin the cab
-
For just a car trip I wrap it in an old wool army blanket with some bootlace ties (or Velcro) to hold it together. Add a canvas strap to sling it over your shoulder.
-
I use a zippered case for a strung longbow when not going to far.
Works good.
John
-
A friend of mine ordered some fishing rods from cabelas and they were shipped in a thick walled (probably 1/4 inch) cardboard tube with removeable end caps I use this tube inside of a sock any time I take the longbow but I haven't flown with it yet, I have no complaints so far.
-
For truck travel just a bow sock to "maximize" the ability to stick the length of bow at an angle with one end on passenger floor board and the other to the corner behind your head. No need for a PVC or heavy protection. Most you are going to do is be drinking a cup of coffee on the way to hunting spot. If you roll your truck on the way I am sure you will break more than your bow. I built a wood frame platform that goes between my wheel wells that is 6" tall. It has 3 slots because I needed to load other stuff on top so two center rails and 2 side rails(open at ends). You can use weather proof materials to cover if you do not have camper shell. When you put tail gate up it secures/protects stuff in platform compartment and you can still can load stuff in bed.
-
Locally just in a bow sock, taking a trip in a PVC tube!
-
I use a Plano Airliner fishing rod case. It is HD, about 6" in diameter and is adjustable for length. You can carry several bows, or a bow and arrow tube. Works great for me.
-
I have traveled the past two years and used a bow sock with PVC. I will add one thing, going through the airlines they will charge you $50 because it is considered a sporting item as in fishing poles or skis. I ended up sending it through the post office a week before with insurance and it was $28, you cant beat that price along with knowing it wont get slammed around by the airlines as bad.
-
-
Thanks for all the great tips/ideas guys!!! I have some time to decide and since I already have the PVC and the bazooka tube, I may just go ahead and keep it one piece!!!
THANKS AGAIN!!!
Stump
ps - Please keep posting new ideas if you have 'em.
-
Place them in a 4" PVC pipe with a screw in end, For air travel put the above in a ski bag. All airlines know what to do with a rosignol bag....
-
Originally posted by straitera:
Had a lot of bows but now one piece only. Just too simple w/o worries. Transport in bowsocks stuffed in pvc tubes if I'm going any distance. My bows are all 68" & 70" ntn.
X2
-
I have a jeep so I just put the seats down and lay it in the back, if shipping ill use PVC or a triangle box and really the heck out of it in bubble wrap. I have a bow sock I also use
-
Google Hatchie Bottom gun sling. (blocked for me, so cant retrieve pic)
It's 2 neoprene "loops" and attaches to each headrest. It's made for guns, but I can carry two recurves in it no problem.
ETA oops, didn't realize how long a bow it was.
-
Home made PVC tube with end caps or an adjustable fly rod case in the bed of my truck when traveling from home to hunt location. Inside an unstrung Kathy Kelly longbow case with quiver opening between the seats of my truck or on the back seat when traveling between stand sites or camp. I stick to longbows 66" or less in length for ease of use. When flying, I have an assortment(4)of TD, two piece longbows to choose from. These go in a TD soft case and in my duffle bag or suitcase surrounded with clothing for protection. Hope this helps.