Trad Gang

Main Boards => PowWow => Topic started by: MJB on May 21, 2012, 10:42:00 PM

Title: Nock Adapters For Carbons Glue/Epoxy
Post by: MJB on May 21, 2012, 10:42:00 PM

What are you guys/gals using ?
Thanks,
Mike

Title: Re: Nock Adapters For Carbons Glue/Epoxy
Post by: MJB on May 22, 2012, 12:23:00 AM

ttt

Title: Re: Nock Adapters For Carbons Glue/Epoxy
Post by: Killdeer on May 22, 2012, 12:48:00 AM

Gorilla glue for the adapter insert, Fletch-Tite Platinum for the nock.

Killdeer   :campfire:

Title: Re: Nock Adapters For Carbons Glue/Epoxy
Post by: amar911 on May 22, 2012, 01:16:00 AM

Marine epoxy.

Allan

Title: Re: Nock Adapters For Carbons Glue/Epoxy
Post by: Guru on May 22, 2012, 06:29:00 AM

JB Weld for the insert bud...then either Fletch-tite or super glue for the nock depending one if I'm in a hurry or not...

Nock adapters have eliminated and cracking at the nock end of the shaft on real hard impacts.

Might occasionally blow a nock off, but no damage to the shaft. Just glue on another nock.

Good stuff!

Title: Re: Nock Adapters For Carbons Glue/Epoxy
Post by: MJB on May 22, 2012, 12:06:00 PM

THANK YOU KINDLY   :campfire: