I'm building spiral wrapped flu flus for the first time and have several questions. I have left wing feathers, and I am using mostly old CX 300's and some Axis 300's for arrows. I shoot right handed and usually right wing but could not find any flu flus that were rw for wrapping (does this matter?). I would like to keep my feathers in the 5 inch range.
I will likely try glue and tape.
Q. Do I clamp one end wrap and then clamp the other end?
Q. How many wraps in the 5 inches do you make?
Q. Which way do you wrap, I heard against the grain or curve of the natural feathers arc?
Q. Do you start at the back or front (or does it matter?
Q. Do you do a complete wrap doubling over on it self to start and stop the wrapping.
any other advise would be a great asset.
Does anyone know of a how to video on this?
Thanks in advance
Tim
Got to the How To section. There's a build along in there for them.
http://tradgang.com/noncgi/ultimatebb.php?ubb=get_topic;f=2;t=000114#000000
found this thread, its great but does not answer all my questions.
If you use tape, attach it to the feather. I start at the rear and wrap down towards the point with about 1/4" to 1/2" spacing. When you get to the end just lay it as before. I then add a thread wrap on the forward end not only to secure the fletch but to protect my hand. I shoot off my hand.
You can wrap the feather any way you want. The purpose of a fluflu is to allow the arrow to so a predetermined distance then slow down and drop. Wrapping different directions will give you a different effect to the flight distance. If you normally fletch with right wing feathers but can only get left wing feathers wrap the fluflu the opposite way you fletched your other feathers.
Any full length split feather like you buy commercially will make a fluflu arrow. You don't have to buy Fluflu feathers.
Thanks Magnus and Pat
Tim
Using contact cement makes it a lot IMHO.
That ought to have the word easier in it.
I second what Pat said, but would like to add to it. Strip the feather from the quill. Perhaps that was understood, but it should be made clear. Spiral wrapping is easy with a feather that's been sripped from the quill. Not so easy with the quill still attached.
Or put the feather in a clamp and rub on a sanding block to reduce the thickness of the quill.
TrueFlight has full length feathers that are cut for spirals. If you want to make things real easy get some along with their instructions.
If you really want a different fluflu check this site I used fletching tape insted of contact glue
http://www.youtube.com/watch?v=HxMVTx9tpQA
Hummer3T, I have done the spiral and they look cool, but I prefer 3 6" feathers that are from a full length feather just cut the length and not the height. You can make them slower with a longer feather or faster with a shorter feather. JMHO