If you are trying to TUNE your arrows and suspect you have a bad release is it ok to barrow a "mechanical :scared: release" from a (wheel/compound) shooter,to smooth out one variable. Keeping everything else the same (arrow length, draw weight and length)to see if your bad release might be giving false/poor arrow impacts/plaining(bare shaft) or bad paper tuning holes. Then by finding out it maybe your release Not the arrow that needs more attention.
Nope. The difference in the way the release and you fingers contact the string will throw your tune off. You have to tune with the exact setup you will be using. If you plan on shooting with a release, it will be fine.
God Bless,
Nathan
NO, I am not planing to use a M release but I have noticed alot of post with trouble tuning thier arrows and wondered if it would help them(short or a hooter shooter) to find the proper arrow spine, taking out one more hair pulling variable "the release".
Your bow,shoot it any way you like. The only thing I can see, is that your draw length will change, if you use the same anchor point. And if you use a different anchor point, you are introducing another variable etc.
Try it and see how you go.
If you plan on shooting fingers, then do not use a mechanical release while tuning. It has an altogether different effect on paradox.
I use a release and I use a fingers the M release will cause your poi. to be lower and will require a different spine.(stiffer)
I have two totally different arrow set ups for fingers and M. release
Here's an interesting video of archer's paradox:
http://www.youtube.com/watch?v=WzWrcpzuAp8
You will completely change the paradox by shooting with a release. That's why the release was invented... because it produces a very different, less variable release, and more consistent arrow flight. But if you are a fingers shooter, you must tune with fingers. If you are a release shooter, you would tune with a release. To mix the two would be akin to sighting a scope to a particular rifle, then taking the scope off that rifle, putting it on another, and thinking that it would still be sighted in.
No...that would be like tuning your friends car motor and expecting yours to run better.
Must tune to YOU and your release....not a mechanical release.
You are part of the shooting system. I really think you have to tune your gear around your style. I think adding the release is adding a variable not removing. I know when I'm having trouble with my release a few minutes ( sometimes more) 5 yards in front of target with my eyes closed focussing on nothing but back tension anchor and relaxing my fingers usually helps a TON!!. Good luck
Not if you have fingers :)
QuoteOriginally posted by Terry Green:
No...that would be like tuning your friends car motor and expecting yours to run better.
Must tune to YOU and your release....not a mechanical release.
Couldn't say it ant better!!! :thumbsup: :thumbsup:
Its already been said, but when you use a mechanical release your arrow flexes up and down. This is not a good thing when shooting off of the shelf or any other rest that puts tension on the arrow from the side (springy, plunger, flipper, etc.) This is why the majority of compound shooters use a rest that supports the arrow only from the bottom....and recently the trend has gone even further, so that the rest moves completely out of the way upon release.
When you release with your fingers, the arrow flexes side to side, which is how you are able to tune setups that aren't centershot so that there is no contact with the plate at all upon release.
Were you to try to tune your setup with a release, you could get it to shoot bullet holes through paper, but your arrow flight would be horrendous when you switched back to fingers.
Scott