Print Page - AD Trad nock inserts

Title: AD Trad nock inserts - what glue?
Post by: WESTBROOK on February 22, 2012, 10:06:00 AM

Got some AD trads and was wondering what is the best glue to use to glue the nock insert into the shaft.

Thanks

Eric

Title: Re: AD Trad nock inserts - what glue?
Post by: JRY309 on February 22, 2012, 11:09:00 AM

I used a slow cure 2-part 24 hr epoxy to glue my nock bushings and inserts in my AD's.But clean and prep it before,I rough up the inside if the shaft and clean everything with alcohol.Haven't had a single problem.

Title: Re: AD Trad nock inserts - what glue?
Post by: joe skipp on February 22, 2012, 01:44:00 PM

I used JB Weld 6 hr cure...no problems. Used them for my brass inserts also.

Title: Re: AD Trad nock inserts - what glue?
Post by: WESTBROOK on February 22, 2012, 03:06:00 PM

Thanks fellas, I think might have some JB.

Thaks

Eric

Trad Gang

Main Boards => PowWow => Topic started by: WESTBROOK on February 22, 2012, 10:06:00 AM