Does anyone make a single broadhead cover for Magnus Snuffers?
I think 3Rivers sells them.
They are simple to make if you care to make your own. Make a pattern from a piece of paper by wrapping it around the head into a cone shape. Overlap the wrap about 1/4" and mark it 1/2" longer than the head. Cut the pattern out then use it to cut a piece of leather for the hood. I like to leave two tabs at the bottom for holes in each to run a piece of leather through to tie it on the shaft of the arrow. Just sew or glue it together at the overlap and your good to go.
QuoteOriginally posted by Al33:
They are simple to make if you care to make your own. Make a pattern from a piece of paper by wrapping it around the head into a cone shape. Overlap the wrap about 1/4" and mark it 1/2" longer than the head. Cut the pattern out then use it to cut a piece of leather for the hood. I like to leave two tabs at the bottom for holes in each to run a piece of leather through to tie it on the shaft of the arrow. Just sew or glue it together at the overlap and your good to go.
:thumbsup: