Don't know if this is the right forum for the question, but here it goes.
I am looking to pick up an older longbow. The bow is in great condition, but the laced leather grip has seen better days.
I am unskilled with a needle and thread beyond sewing on nametags and patches onto uniforms, and I really don't want to "experiment" with a nice bow.
Any suggestions on who does this sort of thing? I did look at the Sponsor's forum, but can't make out who all does this sort of thing and what the final product is like.
And that beaver tail sure looks mighty tempting for a vintage longbow.
Thanks all!
Jim
It is something you can definetly do yourself. I followed direction video i found on 3rivers archery. It turned out really good and took only about 30min. and less that 15 bucks.
http://www.3riversarchery.com/Glue+Adhesives+Specialty++Barge+Cement_c59_s76_p0_i4188_product.html
Video is at bottom of the page.
Clean off exsistng leather and glue residue. Cut to fit. Leather punch sew holes. Barge cemenet up and lace up with artifical sinew.
Good luck.
I'll give it a shot!
Thanks for the info and link.
How does one go about cleaning off the existing leather and glue without damaging the bow finish?
Carefully cut off all leather.
Goo Gone, Goof off, some say wd-40, some say minearal spirits but I would be care with that.
These should get the glue off with some light elbow grease.
Lastly I use denatured alcohol to clean up nicely.
You could also try some of the adhesive leather that 3 rivers carries for bow grips. I've had it on my bow since I got it, easy to attach, no mess and doesn't look too bad...although genuine beaver tail would look nice.
Major, if I can do it so can you. For another reference look in the Aug/Sept issue of Traditional Bowhunter. Easy to follow and produces good results.