Does anyone know what size allen wrench is needed to change a Bitzenburger fletching jig from 3 to 4 feather fletch? :dunno:
Would also like to know what size is used to adjust the feather degree because at the moment I've just been using pliers and its causing some wear.
Thanks,
Ari
I believe it is 5/64ths.
1/8" for the divot screws & 9/64" for the angle adjustments.
I'm sure Eugene is correct for his Bitz. However, I have old and new Bitz's that have different allen sizes. Best to just spring for a set of allens in US sizes. Probably cheaper than buying a couple of single allens anyway.
Yeah I was looking on 3river and they have an allen wrench set, just wanted to make sure it had the sizes I needed.
Thanks
Yeah, mine have different sizes too depending on the age.
mine are 5/64" and are over 20 years old. bought a couple extra allen keys from Ace Hardware for 49 cents each
Yes it is handy to have both sets of allen wrench sizes.
Sears has nice allen wrench sets---both Sae and Metric. They "fold up and fit in your pocket too.
Joe
Just a dumb question, can you get SAE in the land down under? If not those are going to be some expensive allens.