I just ordered a Hoyt Buffalo. I ordered a 50#@28. I draw 30". I would like to shoot a full length shaft. I have a dozen 2117s do you think they would work? If those do not work, I would like some suggestions for axis or FMJ?
Thanks
Eric
I think the 2117's will work, if you are not locked into a point weight. I have found them to be a pretty versatile arrow, but you may need to up your point weight.
I hope so I have an Assenheimer in the same weight range that like 2117 with 145 heads. Just first time with a bow with carbon in the limbs. Do not know if that effects arrow selection that much.
I would guess they'd be too stiff. Maybe with a lot of weight up front. Try Stu's Calculator to be sure.
Bowmania
Full length I bet they will be fine with a minimum of 145, if you cut them to 31"s than you would need a lot more point weight. That Hoyt will be about 57-58#s at 30"s as they stack a tad bit after 29"s but not much. Shawn
Stu's calculator says that will be right on - but maybe too weak if left full-length. I use 2117 wih a 50# recurve, but drawing 29.5 and cutting arrows to 30". I use D-97 and can use either 125 or 145 point weight.