I just started shooting my longbow today and the string keeps slapping just above my wrist. What can I do to reduce this? I am new to tradit http://i1106.photobucket.com/albums/h376/llamma2/018.jpg[/IMG]]web (http://i1106.photobucket.com/albums/h376/llamma2/018.jpg) (http://http:/%5BIMG) ional shooting and any help would be much appreciated. :pray:
What kind of longbow? Can you please post the specs on it ;)
wear an arm guard, and if that doesn't work for you (still don't like the slap), try turing your hand out a little to move your wrist away from the string a little till you find out the sweet spot for you. Try tinkering with your brace height also.
Your brace height may be too low. Check the manufacture recommendation, start at the highest brace height and reduce until you have good arrow flight and accuracy. Either that or your bow arm is too straight or locked at the elbow. You Should have a slight bend at the elbow yet have a straight line of force/support from your shoulder to the grip.
Best of luck!
If you are right handed, roll the bow as far to the right as possible then bring it back to shooting position. Nock an arrow and shoot as normal.
Good stuff so far. I will also add to turn your elbow out some so it is more to the side and not down. Just a bend in the elbow will not help if it is a bend down and not out.
It's a hickery wood longbow 68 in.45@28
Raise the brace height.
Make sure your bow arm has a slight bend to it. If you are straight or straining to pull the bow your arm will bow towards the path of the string. If you keep a slight bow it keeps your arm from fully extending and keeps the string from hitting your arm.
my 2 cents: i got a lot of string slap recently when i went to a carbon arrow for testing. turned out the arrows were stiff in spine and light in weight, only 8.4 gr per inch. they made a lot of noise hitting the riser and most shots caused string slap. rarely ever experience slap with my regular arrows. that's all i got.
Lots of good advice. I would not take another shot without an armguard,you risk developing a flinch in anticipation of the whack on your wrist
I would say brace height and grip . if you hold your hand out with your thumb pointing at 1 O' clock (right handed ) you create a V. the grip of the bow should run straight down the V resting on the fatty portion of you palm below the thumb . this position will turn your elbow out . also watch your footwork, open your stance a little and this will bring your shoulder out . these things combined will move your arm further out of the path of the string . This may not eliminate all string slap but it will greatly reduce it .Then use an armgaurd
You might try to open your stance a little and it should pull your arm away from the string a little.
I switched to wood arrows and bent my arm more.No slap thank you.To long shooting a compound.
Great comments from everyone. You don't want to develop a flinch from thinking your forearm is going to get whacked. I agree with okla bearclaw about opening up your stance a little. Also, as mentioned try raising your brace height, and making sure you're not shooting with a straight elbow. Good luck!
Bernie Bjorklund
NC Iowa/SW Wisconsin
Everyone missed the fast fix - if you're right handed take a half a step forward with your right foot. Just picture that it opens up your stance and takes the string away from your arm. If that doesn't work it's brace height.
I don't like bent arms. Hard to bend them the same every time.
Hold your bow arm out in front of you, bend your elbow so that the forearm comes horizontally across your chest, then extend again. That is the shoulder position you want. If, when you bend the elbow, your hand comes back and hits you on top of the head, this is the wrong shoulder position and you will get whacked. Also- wear an arm guard.
Make sure you can handle 45 pounds and keep good form. 45 is alot to start with.