Does anyone have a picture of how to use a Dremel tool as a cut off saw? I read where some have done this.
These may help.
http://tradgang.com/noncgi/ultimatebb.php?ubb=get_topic;f=1;t=092967#000000
http://tradgang.com/noncgi/ultimatebb.php?ubb=get_topic;f=1;t=094872#000002
Redogge, I just used a 1.5" 2-hole conduit strap and screwed it to the bench, not too tight though. works like a champ.
Eric
no need to mount it just hold with your hand and wackem off,put a nail in your workbench and measure out lengths from there.just lower the blade straight down onto shaft, thats how i do it.
Thanks for the tips.
I use a piece of angle iron as a holder gizzy and use my Dremel Multi-Max tool with a combination blade. Works so far with any material.
I clamped mine to a pc of corner molding I had laying around and for a stop I used a short pc of break line and the nut that came with it.Clamp on the nut and the steel line will turn inside.Good luck
QuoteOriginally posted by arrow30:
no need to mount it just hold with your hand and wackem off,put a nail in your workbench and measure out lengths from there.just lower the blade straight down onto shaft, thats how i do it.
Is this with carbons?