Was curious if anyone else has footed a Gold tip blem (I plan on ordering from Big Jim). If you have, which aluminum arrow size did you use?
I shoot a predator 54# @ 28, but draw to about 30+ inches. So maybe around 60# draw or so. Suggestions on which GT to order? I find 400's shoot good or 2117 at around 30 inches.
Point weight? arrow length? Anyone shoot anything similar? I'm open to any suggestions. Thanks Ben
55/75 with a 150 up front is what i shoot whith these out of my bw@59@29
Thanks for the info. GT chart is putting with the 300 size, but I've shot 340's from this with 225 up front with a 31 inch arrow and they are too stiff. 55/75 sounds good I will probably settle with that at maybe 30 1/2 or so.
Has anyone footed a 55/75 with an aluminum arrow? If so what did you use?
I have another question about footingalso. do you guys buy a pack of alum. arrows just to cut up and glue on the end of carbons? also theres a link in the diy section they have the size arrow matched with the size footing
O nice, I'll check that out. From what I understand I've seen sections of aluminum about 2 inches or so, epoxied to the end of a carbon arrow. Not sure, but I'll check that section out.
Thanks for the heads up.
Well I think I've got it, thanks for the help guys. Looks like 30 1/2 inch 55/75 I'll mess with the point weight and see what it likes.
And footed with a 2216.
Thanks again!
I sell a carbon collar that will do the same thing and only add a few grains to the shaft. Easy to install.
Thanks,bigjim