Print Page - Lansky Sharpener what degree for Bear broadheads??

Title: Lansky Sharpener what degree for Bear broadheads??
Post by: david janssen on September 18, 2010, 10:16:00 PM

Just wondering what degree I should use for sharpening my Bear Broadheads with my Lansky sharpener?

Thanks for the help.

Title: Re: Lansky Sharpener what degree for Bear broadheads??
Post by: Ward / Texas on September 18, 2010, 10:47:00 PM

Magnus recommends 22 degrees for thier Stinger, and so that maybe a good start.

Ward

Title: Re: Lansky Sharpener what degree for Bear broadheads??
Post by: JimB on September 18, 2010, 11:16:00 PM

I don't have any new Razorheads to measure but the ones I have that have been sharpened a good bit,are close to 20 degrees.

The best way to check is black out the ground edge with a felt tipped marker,clamp the head and work the stone across it and you will see right away which angle contacts the blade best.You can figure it out in a minute.

Title: Re: Lansky Sharpener what degree for Bear broadheads??
Post by: david janssen on September 19, 2010, 07:36:00 AM

Thanks alot

Trad Gang

Main Boards => PowWow => Topic started by: david janssen on September 18, 2010, 10:16:00 PM