Just receeived this quiver from Three Rivers.New to Traditional bow....The instructions state first you must adjuste the quiver for length but it doesn't tell you how to do that. Call me stupid but I need some help. :banghead:
Look at where the two steel rods meet thier are rubber srink tubes on each end pull the bottom and the top at the same time its hard to slide.The best quiver made IMO.
The top(hood) and bottom(shaft gripper) should have independent metal rods that are joined by bands wrapped around them. THe quiver is actually in two pieces that are held together by these bands.If you grip each rod by their ends and pull, they will start to slide apart. Dont grab by the hood or arrow gripper...grab the rods.
pulled them both down?
or pull in opposite directions?
Opposite.
call me stupid but I can't get the wires to move.Thanks though.
could be my broke wrist....LOL
thanks guys.I quess I will have to find someone that can pull the wires for me. Broke my arm on Father's day. Had a plate inserted. Still a weakling...Less I know how it works. Thanks.
Thanks everyone. Mission accomplished. My 115 wife did the job for me. :clapper: