Trad Gang

Main Boards => PowWow => Topic started by: jcprintz on August 30, 2010, 02:38:00 PM

Title: 1 1/4" VPA Terminator Broadheads
Post by: jcprintz on August 30, 2010, 02:38:00 PM

Can anybody help!
I know VPA doesn't make these anymore but does anyone know where I can buy 6 or so, preferably 250 grains. I just aquired some VPA 200 grain screw-ins and can't believe there is another screw in broadhead that spins as well. I just wish they were wider. I think that Big Jim's new head might be too big for my setup (50# @ 27" Zipper longbow).

Title: Re: 1 1/4" VPA Terminator Broadheads
Post by: TOEJAMMER on August 30, 2010, 02:51:00 PM

Check out Big Jim's post on POW WOW.  VPAs but wider.  Unless mistaken, they are 300 grain screw in.

Title: Re: 1 1/4" VPA Terminator Broadheads
Post by: lpcjon2 on August 30, 2010, 03:19:00 PM

place a wanted add on the classified forum in the main page.

Title: Re: 1 1/4" VPA Terminator Broadheads
Post by: Longbow338 on August 30, 2010, 06:14:00 PM

Call vpa and ask get as many people as you can to do so He said he would run another batch of 1 1/4 250gr if there is enough interest.

Title: Re: 1 1/4" VPA Terminator Broadheads
Post by: BigJim on August 30, 2010, 07:11:00 PM

jcprintz- if the 1.25" vpa isn't too big, the BigJim won't be either. It is a little heavier, but that could easily be accounted for.
I might have a few 1.25" vpa's on hand too.
thanks,bigjim

Title: Re: 1 1/4" VPA Terminator Broadheads
Post by: Apex Predator on August 30, 2010, 08:57:00 PM

The  1 1/4" VPA Terminator is longer than the Big Jim head.  The blade angle is a good bit steeper on the Big Jim.

Title: Re: 1 1/4" VPA Terminator Broadheads
Post by: Bob Morrison on August 30, 2010, 09:18:00 PM

300 gr. put close to where it should be and your making meat. Got VPA and Big Jims and even at my draw and poundage, the broadhead won't be an issue, my accurancy maybe.
Do 300 gr.