Print Page - What glue do you use

Title: What glue do you use
Post by: bkbk12 on August 16, 2010, 10:54:00 AM

I was just wondering what glue everyone uses to put in adapters. All I have is fletch glue but ws looking at some epoxy.

Title: Re: What glue do you use
Post by: **DONOTDELETE** on August 16, 2010, 10:56:00 AM

When I shot Easton Arrows I would just use duel-temp glue sticks from Wally World AKA Wal-Mart.

Title: Re: What glue do you use
Post by: Whip on August 16, 2010, 10:59:00 AM

I use hot melt because it allows for easier removal later if I need to. But the epoxy should work as well.

Title: Re: What glue do you use
Post by: lpcjon2 on August 16, 2010, 11:11:00 AM

Ferrel Cement or hot glue.

Title: Re: What glue do you use
Post by: Night Wing on August 16, 2010, 11:17:00 AM

Bohning Fletch Tite.

Title: Re: What glue do you use
Post by: Steertalker on August 16, 2010, 12:28:00 PM

JB Weld

Title: Re: What glue do you use
Post by: cbCrow on August 16, 2010, 01:30:00 PM

Hot melt.

Title: Re: What glue do you use
Post by: NewtoTrad2008 on August 16, 2010, 01:35:00 PM

I use epoxy and they hold great, and with a little heat you can get them off without too much trouble.

Title: Re: What glue do you use
Post by: Gen273 on August 16, 2010, 03:06:00 PM

Goat tuff

Title: Re: What glue do you use
Post by: kbaamigo on August 16, 2010, 04:08:00 PM

I use hot melt but clean adapter and inside of shaft with alcohol before.

Trad Gang