I just got a test kit of trad only carbons,what do you do to prep them for fletching? rough them up? dip them? wipe w/ acetone? or nothing at all?
There is usually a bit of carbon dust on mine,...and I wipe off the fletch area with a wet rag.....and let them dry and fletch.
I do use acetone to take off the gold writing paint.
I would bareshaft them to figure out which is best for setup. I use denatured alcohol or acetone to prep shaft and inside for inserts. I scour the inside of shaft with brass gun brush and then clean with Qtip and acetone.
Okay, when I bs them do I cut to my normal lgth. or go through the torture of triming a 1/4 off full lgth.as I go?