Print Page - Aluminum Shaft Selection Advice

Title: Aluminum Shaft Selection Advice
Post by: fz4vgq on April 22, 2010, 08:13:00 AM

Hey Guys,

I'm getting all different kinds of results on different shaft selection charts. Here is what I am going to be working with:

Shrew Classic Hunter 54"
bow is 58# @ 28"
I draw 25" and figure 49 pounds at that length

I've gotten results anywhere from 1816's to 2114 for a 27" arrow length.

I'd appreciate any input/help with this.

Thanks

Title: Re: Aluminum Shaft Selection Advice
Post by: wingnut on April 22, 2010, 08:30:00 AM

Use Stu's calculator to look it over. Is the Shrew cut to center or beyond?

Mike

Title: Re: Aluminum Shaft Selection Advice
Post by: fz4vgq on April 22, 2010, 08:54:00 AM

Thanks Mike. I'm at work right now and for some reason any link to Stu's Calculator is "restricted" here at work.

I am not sure if this Shrew is cut to center or past. Does anyone know what is normal/common on Shrew Classic Hunters ? I'm not in possesion of the above mentioned Shrew just yet.

Title: Re: Aluminum Shaft Selection Advice
Post by: wingnut on April 22, 2010, 08:55:00 AM

Chadd,

Send me an email and I'll send you a copy of the calculator.

wingnut@dryadbows.com

Title: Re: Aluminum Shaft Selection Advice
Post by: fz4vgq on April 22, 2010, 01:10:00 PM

Thanks Mike !

Played around with Stu's calculator program you sent me, it is an amazing tool.

Title: Re: Aluminum Shaft Selection Advice
Post by: wingnut on April 22, 2010, 01:12:00 PM

It'll get you close. Then the tunings up too you.

Mike

Trad Gang

Main Boards => PowWow => Topic started by: fz4vgq on April 22, 2010, 08:13:00 AM